Herunterladen Inhalt Inhalt Diese Seite drucken

Replay XD 1080 Mini Bedienungsanleitung Seite 6

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 29
1. Find the best mounting location for your Replay XD 1080 Mini and check your angles.
Rigid surfaces are ideal for the best video quality. Note: You can make a test recording and
check it on an iPad/Mac/PC.
2. Flip LowBoy mount upside down and carefully spread, insert Replay XD 1080 Mini
into holder with buttons passing through the cut-out.
3. With the Replay XD 1080 Mini centered in LowBoy mount, rotate 360º to desired
rotation.
4. Slide LowBoy mount into SnapTray until it is fully seated and clicks. The LowBoy mount has
rubber strips to hold your Replay XD 1080 Mini from rotating when seated, make sure your
rotation angle is ideal. You can make fine adjustments by sliding the LowBoy in/out of the
SnapTray.
5. Attach VHB SnapTray adhesive mount to a clean smooth surface.
The 3M VHB adhesive is not recommended for textured surfaces.
VHB SnapTray
See our full range of mounts at www.Replayxd.com
LowBoy Mount
Unlock
Lock
Use rubbing alcohol to clean
the mounting surface. Wipe
dry the surface. Apply your
VHB mount to surface. Press
and hold for sixty seconds to
allow adhesive to bond to
the surface. Bond strength
will increase through time.
At room temperature,
wait for at least 24 hours
to achieve 90% bonding
strength, and 72 hours for
100% bonding strength.
LO W B OY M O U N T
IMPORTANT

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis