Replay XD 1080 Mini Bedienungsanleitung Seite 5

1. Find the best mounting location for your Replay XD 1080 Mini and check your angles.
Rigid surfaces are ideal for the best video quality. Note: You can make a test recording and check
it on your Mac or PC.
2. Snap Replay XD 1080 Mini into u-shape camera holder and rotate 360º to desired rotation.
3. Attach VHB SnapTray adhesive mount to a clean smooth surface.
-Flat SnapTray' s are good for flat smooth surfaces.
-Curved SnapTray' s are good for curved surfaces such as Helmets & Radius surfaces.
The 3M VHB adhesive is not recommended for textured surfaces.
4. Slide HeimLock mount into SnapTray until it is fully seated and clicks.
5. Adjust swivel 360º or tilt ~8º by releasing the heim cam lever and position Replay XD
1080 Mini in desired direction, then lock the cam lever. Make sure the cam lever is tight.
There is an adjustable tension wheel and phillips screw ( * ) to make sure you always have
a positive tight lock. You can tighten the screw clockwise in 1/4 turn increments to find
the desired tension when the cam lever is locked.
VHB SnapTray
Tighten
Set screw
See our full range of mounts at www.Replayxd.com
HeimLock Mount
Swivel
*
Unlock
Lock
Tilt
H E I M LO CK M O U N T
IMPORTANT
Use rubbing alcohol to clean
the mounting surface. Wipe
dry the surface. Apply your
VHB mount to surface. Press
and hold for sixty seconds to
allow adhesive to bond to
the surface. Bond strength
will increase through time.
At room temperature,
wait for at least 24 hours
to achieve 90% bonding
strength, and 72 hours for
100% bonding strength.