Punching Time And Punching; Capacity; Maintenance; Storage And Transport - Rittal 4055.040 Bedienungsanleitung

12 Punching time and punching capacity
Note:
If you want to charge 2 batteries one after
another, wait approx. 15 minutes before
nd
you load the 2

12 Punching time and punching

capacity

22.5 mm Ø St. 37 2 mm 5 sec
63.5 mm Ø St. 37 2 mm 7 sec
68 x 68 mm St. 37 2 mm 7 sec
Tab. 3: Punching time and punching capacity

13 Maintenance

The device is designed to be maintenance free.
If the device should not build up pressure contact the
distributor or the after-sales-servic

14 Storage and transport

After use put the punching unit back into the transport
case. Store in a dry place.
Fig. 14: Transport case
Electric hydraulic punch assembly instructions
battery.
Punching Punching
time capacity
190 Holes/
Battery
100 Holes/
Battery
70 Holes/
Battery

15 Disposal

The disposal of the individual components must occur
separately. The oil must be drained first and then dis-
posed.
Danger!
At disposal of all parts of the unit please
respect the EC-Environmental-Norm.
Danger!
Hydraulic oils pose a danger for the
ground water. Uncontrolled drain or
inappropriate disposals are strictly
forbidden.
Danger!
The Battery must be disposed under
special consideration of the battery
directive.
Danger!
The device must not be disposed as a
complete unit into the residual/non-
recyclable waste because it could cause
damage to the environment on the
landfill.
EN
17