Ecatronic FlAT SAT 650/800 1 P Installationshandbuch Seite 24

6.4.1 PROBLEMS AND SOLUTIONS CONTROL PANEL 1 P
Unlike the LED and DISPLAY versions this type of control panel manages errors through
light impulses and acoustic warning signal sequences. When a functional error occurs the
red led turns on in a fixed mode. To find out what kind of error has occurred you only have
to press the ON/OFF button. A series of flashing and acoustic signals will indicate what
kind of error is underway. Please see the below table.
SIGNAL DESCRIPTIONS
1 flash with 1 beep
2 Flashes with 2 beeps
3 Flashes with 3 beeps
4 Flashes with 4 beeps
5 Flashes with 5 beeps
6 Flashes with 6 beeps
7 Flashes with 7 beeps
8 Flashes with 8 beeps
9 Flashes with 9 beeps
10 Flashes with 10 beeps
WARNING ! To clear your antenna from any errors, push the ON/OFF button for 5
seconds until the green LED begins to flash.
If the error is correctable the antenna will begin to function normally; if not then
you must contact your nearest service center.
PROBLEMS
- vertical rotation error
- horizontal rotation error
- maximum effort error
- satellite not found error
- battery
- check RF cable
- violation error range vertical
- violation error range horizontal
- key camper ON
- power unstable error
24