Ecatronic FlAT SAT 650/800 1 P Installationshandbuch Seite 11

In many cases the connection is on pin 15 of the general terminal board and in any case
it corresponds to an active and positive voltage of +12 VDC generated when the vehicle
ignition key is rotated.
This connection prevents the operation of the satellite dish when the vehicle is moving
or the ignition key is turned for ignition.
DECODER
DECODER 2
DECODER 1
WIRING DIAGRAM, ONE-OUTPUT VERSION
NOTE: THE DECODER AND ITS CABLE ARE NOT INCLUDED
WIRING DIAGRAM, ONE-OUTPUT VERSION
NOTE: THE DECODER AND ITS CABLE ARE NOT INCLUDED
BLACK CABLE
11
7
RED CABLE
BLACK CABLE
TO THE IGNITION KEY OF THE
VEHICLE (+ 12 V CURRENT)
7.1 7.1
RED CABLE
TO THE IGNITION KEY OF THE
VEHICLE (+ 12 V CURRENT)