Operation Via The Keyboard - HBM MP30DP Bedienungsanleitung

28
5

Operation via the keyboard

During measurement you can press
the display (e.g. mV; V; Out,In; error messages).
Next to the status message "ERROR" the display shows the status of the
Profibus DP connection. One of the following status messages is displayed in
each case:
BD_SEAR (baud rate search)
WT_PARM (waiting for parameter)
WT_CONF (waiting for configuration)
DATA_EX (cyclical data traffic)
ERROR (bus error)
The LED shows the operating status (ready to take measurements, overflow
etc.) of the MP30DP. Instead of the CAN status, however, the Profibus status
is displayed (as is the case with the PM30).
Operating status:
LED
colour
Green
Yellow
Red
The representation of the other operating statuses is the same as that of the
MP30.
HBM
Status
Steady light DATA_EX status
Steady light BD_SEAR, WT_PARM, WT_CONF status
Steady light ERROR status
− to view the status messages in
−
+
Meaning
Profibus status
PME-MP30DP
A0737-4.0 de/en/fr