Caretero DIABLO XL Bedienungsanleitung Seite 16

4 ADVICE ON PROPER CHILD SEAT PLACEMENT IN YOUR CAR
Proper placement
2-point
lap belt
5 INSTALLATION FOR GROUP I (9-18 KG)
Place the car seat forward-facing on a passenger seat in the car and push it against the backrest. Adjust the seat tilt
position to maximally inclined - position 3 (see point 9). Unfasten the linking rod on the side of the seat shell (A-1).
Remove the linking rod and put it aside. Push the seat away from the back of the car seat (A-2). Now you can easily
access the belt guides. Unlock the top belt guide on the side of the car belt buckle.
Slide the lap part of the car belt through both lower belt guides. Open the unlocked shoulder belt guide. Slide the
shoulder belt through the guide (A-3).
Lock the belt guide. The upper part of the shoulder belt should go through the center of the top part of the seat shell.
Use the linking rod to connect the seat back with the seat shell (A-4). Pull the shoulder belt in the direction of the car
belt tensioner to tighten the car belts (A-5).
Make sure the car seat is pressed tight against the passenger seat backrest and that the car belts are properly
tightened and not twisted.
3-point
shoulder
and lap belts
?
1
?
2
Forbidden placement
A car seat of this type may be used only in a car
equipped with seat belts with a 3-point tensor and
a 3-point rolling-up element, which complies with
the UN/ECE Regulation nr 16 or other equivalent
standards.
? Installation of the child seat is NOT
RECOMMENDED if the passenger
1
seat airbag is active.
?
Installation of the child seat is
2
FORBIDDEN if the passenger seat is
equipped with a 2-point seat belt
only.
13