Putting Into Operation Of Mtxh Pit / Lagoon; Mounting The Mixer To A Tractor - Bauer MTXH Betriebsanleitung

The clamp is mounted and locked as described above.
3.2 Putting into Operation of MTXH-L
WARNING!

3.2.1 Mounting the Mixer to a Tractor

The three-point block of the mixer is dimensioned according to ISO 730 and it corresponds to the mounting
categories 2 and 3N. It is mounted by means of the upper and lower linkage bolts supplied along. It is not
imperative to use a hydraulic upper linkage since sufficient variability is given to position the mixing rod correctly
by the lower linkage hydraulics of the tractor and by the mixer hydraulics.
Hydraulic connections:
For tractors equipped with position hydraulics it is essential to switch over to position control.
It is important to prevent the lower linkage hydraulics from lateral swinging in a way that the guard bow can be
moved by max. ±20 cm. This is of great importance for cornering and when the mixer is in operation.
13
Operating Instructions for BAUER TRACTOR TURBOMIX / Version X-2014

Do not start the mixer before it has been lowered into the pit.

Make sure that nobody stays in the hazard area of the machine and at the pit
opening during operation (CHILDREN!!!).

For cut-to-length, profiled tube fitting and maintenance, see separate Operating
Instructions.

Check length of articulated shaft on:
Sufficient tube overlap at widest position of articulated shaft.
-
Articulated shaft can yet be telescoped at shortest position of articulated
-
shaft.
Eventually length corrections will be necessary (see instructions for
-
articulated shafts).
The hydraulics of the hoisting frame of the MTXH and MTXH-L needs a double-acting
control unit.
The additional swivelling device needs a double-acting control unit.
8 bolted connections SW 24