Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Secure the zigzag foot.
2. Select the right stitch, set the stitch length to 4mm and lower the thread tension.
3.
Sew parallel stitches with 1 cm intervals. TAKE NOTE: you do not need to sew
reverse/strengthening stitches or cut off the thread.
4. Pull the lower thread to create pleats. Iron the pleats with an iron.
Embroidering (illustration 48 & 49)
Pressure foot
Choice of pattern
None
Zigzag stitch
1.
Place the embroidery plate on the needle plate.
2. Set the choice of pattern button to the required zigzag stitch.
3.
Tighten the material as much as possible between the embroidery rings (not supplied, can
be obtained at speciality shops) with the inside of the material to the underside of the
inner ring.
4. Place the work underneath the needle and lower the foot lever without using the foot pedal.
5.
Turn the fly-wheel and pull the lower thread up through your work at the starting point.
Make a few attachment stitches.
6
Pick the ring up between the thumb and index finger of both hands and apply pressure to
the material with your middle and ring fingers. You can then use your little finger for
support on the outside of the ring.
COMMENTS:
a. Stitch around the outline of your design by moving the embroidery ring.
b. You can now fill your design by first sewing from the outside to the inside and then from
the inside back to the outer edge, until the entire design is completed. Ensure the stitches
run alongside each other.
c.
You can create a long stitch by moving the embroidery ring quickly. A short stitch is
achieved by moving the ring slowly.
d. Sew a few straight stitches at the end to finish off.
Making buttonholes (illustration 38)
Pressure foot
Choice of pattern
Buttonhole foot
(
(
PREPARATION
1
Determine the length of the buttonhole
2
Draw the centre line with a piece of chalk.
REMARK
Try this first on a piece of the same material, before you actually set to work. (illustration 39)
Setting to work
1
Place the material and see to it that the middle of the pressure foot runs even with the line
that was drawn on the piece of material. Then move the plate of the pressure foot and let
the opening of the pressure foot run even with the drawn hole.
2
Set the button for the choice of pattern to A. Stop sewing when you reach the marked chalk
Stitch length
All
Stitch length
)
( )
0.3~1
)
English
33
Werbung
Inhaltsverzeichnis
