Connect The Remote To Your Tv - smartuptv SUT2001 Handbuch

6 Connect the remote to your TV

A: Turn the TV on and press the
B: Press the keys
near the
LED a new frequency code is send. (view image 30 for all codes)
Now pay attention to the TV.
When the TV turns off while scanning press
stored.
Now the remote is set to your TV.
If the TV does not turn off while scanning please start again with step B.
It is possible that your TV reacts to a different code. In that case not all keys will work as intended.
Restart the frequency scan and use a later code this time.
C: Press now the
Image 30: Remote
and simultaneously for about 5 seconds until the LED light
key comes on. The frequency scan is starting. With every flashing of the
key to turn the TV on.
key on the remote.
within 5 seconds the key and the frequency is