Technical Data; Troubleshooting; Possible Cause - Grundig CDP 410 Handbuch

TECHNICAL DATA

Power Supply
AC power adapter .......DC 6.0 V +>- external
Battery operation ..........2 x 1.5 V (LR6, AM3, AA)
Output power DIN 45324, 10% THD
Earphone output ...............................2 x 15 mW
Line output................................0.6 V +/-1.5 dB
Connections
Line Out ...................................3.5 mm ø stereo
DC connector...........................3.5 mm ø (6.0 V)
Earphones: ..............................3.5 mm ø, stereo
CD Player
Frequency range:.......................20 Hz – 20 kHz
S/N ratio, weighted .............................> 80 dB
Channel separation ...............................> 52 dB
D/A conversion .................1 bit linear digital filter
Dimensions (w x h x d)....133 mm x 31.5 mm x 137 mm
Weight (without batteries) ..............approx. 0.3 kg
Supplied accessories
.....................AC power adapter/battery charger
..............................................Stereo earphones
...............................................Guarantee sheet
.............................................Instructions for Use
This unit meets the CEE regulations concerning
interference radiation.
This product fulfills European directives
89/336/EEC, 73/23/EEC and 93/68/EEC.
This unit complies with the safety regulations
according to VDE 0860 / BS 415 and thus with the
international safety regulation according to IEC 65.
The type plate is located on the bottom of the set.
Subject to technical alterations and alterations in
styling E. and O.E.

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate
the guarantee.
Problem

Possible Cause

No power or no Batteries/rech. batt.
CD play start Batteries incorrectly inserted
Display: no indication Batteries are empty
The LOCK switch is in
the ON position
Contact pins are dirty
AC power adapter
Loose connection
CD play does not start CD lid is not securely closed
or interrupts Moisture condensation
Display: no indication or
CD is not or incorrectly inserted
dl SC
CD is badly scratched
CD is dirty
Play does not start RANDOM or PROGRAM
from the first track is activated
No sound or bad PAUSE is activated
sound quality Loose or wrong connections
Volume is not turned up
Earphones worn the wrong
way round
Earphone plug is dirty
Strong magnetic fields near the
CD player
Electrostatic discharge from
the user via the CD player
The earphone is plugged into
the LINE OUT socket.
Remedy
Insert the batteries correctly
Change/recharge the
rechargeable batteries
LOCK switch in position OFF
Clean them with a cloth
Connect the adapter securely
Close the lid securely
Leave the player in a warm place
until the moisture evaporates
Insert a CD, label facing up
Use another CD
Clean the CD
Switch off RANDOM or
PROGRAM
Press 2; PLAY/PAUSE
Check connections
Adjust the volume
Pay attention to the L (left) and
R (right) indications
Clean the earphone plug
Change the player's position or
connections
Press SEARCH S or SKIP T
once or press 2; PLAY/PAUSE twice
Plug earphone into PHONE socket
GB
15