General Safety Instructions; Overview Of The Components; Start-Up Of The Device/Introduction; Instruction Manual - AEG SR 4304 CD Bedienungsanleitung

General safety instructions

To avoid the risk of fi re or an electric shock, you should
not expose the device to rain or moisture. Consequently,
do not use the device in the immediate vicinity of water
- for example near a bath tub, a swimming pool or in a
damp cellar.
Use the device only for the intended purpose.
Only connect the device at a properly installed plug
socket. Pay attention that the specifi ed voltage corres-
ponds to the voltage of the plug socket.
When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries
in the correct direction.
Assemble the device in such a way that the available
ventilation openings are not covered.
Never open the housing of the device. Incorrect repairs
can constitute a considerable risk for the user. Should
the device become damaged, in particular the mains
supply cable, do not operate the device any longer, but
rather have it repaired by an expert. Check the mains
supply cable regularly for damage.
For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manuf-
acturer, our customer service department or a similary
qualifi ed person.
If the device is not used for a longer period, remove the
plug connector from the plug socket or take out the
batteries.
These symbols may be found on the machine and are
intended to indicate the following:
The lightning symbol should advise the user
of parts in the inside of the device which carry
dangerously high voltage levels.
The symbol with an exclamation mark should
advise the user of important operation or
maintenance instructions in the accompa-
nying documentation.
Devices bearing this symbol work with a
„class 1 laser" for tracing the CD. The built-in
safety switches should prevent the user being
exposed to dangerous laser light, which is
invisible to the human eye, when the CD compartment
is opened.
Under no circumstances should these safety switches
be bypassed or manipulated, as this could result in a
danger of exposure to the laser light.
5....-05-SR 4304 AEG 25

Overview of the Components

1 CD compartment
2 CD STOP button
3 / II CD PLAY/PAUSE button
4 REPEAT button
5 PROG button (CD programming)
6 PROG. control lamp
7 LED display
8 FM/ST control lamp
9 Loudspeaker
10 I SKIP button (skip backwards)
11 I SKIP button (skip forwards)
12 Tab for opening the CD compartment
13 PHONES (headphone connection)
14 Handle
15 POWER switch (AC/DC)
16 ANT Antenna
17 Regulator TUNING
18 BAND Band selection switch (AM/FM/FM ST)
19 VOLUME +/- (volume control)
20 FUNCTION Function selector (TUNER/OFF/CD)
21 Battery compartment

Start-up of the device/introduction

• Read the operating instructions thoroughly before the
start-up!
• Select an appropriate location for the device, e.g. a
dry, flat, non-slip surface on which the device can be
easily operated.
• Make sure that the device is adequately ventilated!
Power supply
Insert the mains plug (see battery compartment) into a
correctly installed 230 volt, 50 hertz shockproof socket.
Please ensure that the mains voltage corresponds to the
information on the type plate. Please ensure that during
mains operation the POWER switch (15) on the back is
turned to AC, and during battery operation to DC.
Close the battery compartment, making sure not to trap
the mains lead.
25
23.07.2004, 8:27:01 Uhr