Behringer X32 Compact Schnellstartanleitung Seite 7

12
X32 COMPACT DIGITAL MIXER
X32 COMPACT DIGITAL MIXER Getting Started
Getting Started
(EN)
Ch01 01
A: S16
01: 0:00 - 0:00 B: -
home
analog out p16 out card out
aux out aes50-a
Channel Processing Block Patch
Inputs 1-8 Inputs 9-16 Inputs 17-24 Inputs 25-32 Aux In 1-4
Local In 1-8 Local In 1-8 Local In 1-8 Local In 1-8
Aux 1-4
Local In 9-16 Local In 9-16 Local In 9-16 Local In 9-16
Local 1-4
[Local In 17-24] [Local In 17-24] [Local In 17-24] [Local In 17-24]
AES50 A1-4
[Local In 25-32] [Local In 25-32] [Local In 25-32] [Local In 25-32]
AES50 B1-4
AES50 A1-8 AES50 A1-8 AES50 A1-8 AES50 A1-8
Card 1-4
AES50 A9-16 AES50 A9-16 AES50 A9-16 AES50 A9-16
AES50 A17-24 AES50 A17-24 AES50 A17-24 AES50 A17-24
AES50 A25-32 AES50 A25-32 AES50 A25-32 AES50 A25-32
AES50 A33-40 AES50 A33-40 AES50 A33-40 AES50 A33-40
AES50 A41-48 AES50 A41-48 AES50 A41-48 AES50 A41-48
AES50 B1-8 AES50 B1-8 AES50 B1-8 AES50 B1-8
AES50 B9-16 AES50 B9-16 AES50 B9-16 AES50 B9-16
AES50 B17-24 AES50 B17-24 AES50 B17-24 AES50 B17-24
AES50 A25-32 AES50 A25-32 AES50 A25-32 AES50 A25-32
Routing I/O Input Signals can be attached to the console's internal
audio processing engine in blocks of 8 signals from any
The X32 COMPACT console features 16 analog rear-panel
one of the aforementioned input sources.
XLR inputs with microphone preamps, as well as
8 rear-panel XLR Outputs and 6 TRS Aux Sends and Note: All signal blocks patched to the audio
Returns. In addition, there are two AES50 ports, processing will be connected to the corresponding
each featuring 48 input and output channels, and a card input channels automatically.
slot for 32 channels of input and output to and from a
connected computer via USB 2.0.
Ch01 01 A: S16
01:
0:00 - 0:00 B: -
analog out
p16 out card out
home aux out aes50-a
Edit Output Assignment
Analog Output Current Setting Category Processed Output Signal Tap
Output 01
MixBus OFF OFF Pre EQ
Output 02
Main (LRC) Main L Post EQ
Output 03
Mix Bus Main R Pre Fader
Output 04
Matrix Main C/M Post Fader
Output 05 Direct Out Main Bus 01
Output 06 Monitor Main Bus 02
Output 07 Main Bus 03
Output 08 Main Bus 04
*Output 09 Main Bus 05
*Output 10
Main Bus 06
*Output 11
Main Bus 07
*Output 12
Main Bus 08
*Output 13
Main Bus 09
*Output 14
Select Select Select
Assign
Local inputs 17-24 and 25-32 are listed with brackets,
13:45 indicating that these are not physically available on
A: 48K
: 19
C: X-USB
this device. Assigning these will obviously carry no
aes50-b
signal, but they can still be used when preparing
shows for a full X32 console.
Connected Devices
AES50 A
Cabling for all AES50 connections between X32 and
S16 stageboxes:
Shielded CAT-5e cable, Ethercon terminated
•
cable ends
AES50 B
Maximum cable length 100 meters (330 feet)
•
Output Signals can be freely assigned from
A: 48K 14:09 any internal signal to any of the following outputs:
: 37
C: X-USB
8 analog local XLR outputs (with adjustable
aes50-b •
digital delay for time-alignment of speakers)
8 virtual outputs (marked with *) for routing over
•
0.3 ft
AES50 or card outputs
0.10
m
0.3 ms
6 auxiliary sends on ¼" TRS outputs + 2x
•
AES/EBU outputs
Delay
16 channels personal monitoring using the
•
console's P-16 Bus output connector
Delay
Any and all of the above signals can also be mirrored
in blocks of 8 signals on either one of
Delay
Select
0.3 ms
48x channels on AES50 port A
•
Set Delay
48x channels on AES50 port B
•
32x channels on USB interface card
•
13
Quick Start Guide
01
Ch01 A: S16
01: 0:00 - 0:00 B: -
con g
home gate dyn eq
Insert Position
clip
t
In
-6
48V
-12
Reverse
-18
Delay Pre
-24
0.3 ft
-30
Source
Link Lo Cut
0.10 m
-36
OFF
-42 +0.0 dB 2.0 Hz Input 01 0.03 ms
-48 Input 02
Input 03
-54
Input 04
Gain Lo Cut Delay
Input 05
Input 06
Gain Lo Cut Source Delay
+0.00 dB 20 Hz Input 0.3 ms
Link Lo Cut Select Delay
LeOnde.mp3 13:44:43
00.05.00 00.00.00 29 November 2010
con g
home gate dyn eq
Bus Con guration Bus Insert Position
clip
∑
-6 Channel Sends
-12
-18
Link Pre
-24
-30
All Channel Sends
-36
Pre Con guration
-42
...
-48
Inputs
-54
Pre EQ
Pre Fader
Post Fader
Sub Grou
Gain Send Pos.
00.00 dB Inputs
Link Bus Sends
The configuration of Mix Bus Channels 1-16 can Main Bus Channels LR/C are always available and
be pre-set (in the Setup/Global page) or can also independent from Mix Buses. The processing steps
be configured on an individual, per-channel basis. for this signal path include (in this order):
The bus processing includes (in this order):
Insert point (swappable between post-EQ and
•
Insert point (swappable between post-EQ and pre-EQ operation)
•
pre-EQ operation)
6-band fully parametric EQ
•
6-band fully parametric EQ
•
Compressor/expander (swappable between
•
Compressor/expander (swappable between post-EQ and pre-EQ operation)
•
post-EQ and pre-EQ operation)
Bus sends to 6 matrices
•
Bus sends to 6 matrices
•
Main LR panning
•
Mono/Center level
•
Input Channels 1-16 are pre-configured to use
14:11 the local input signals 1-16, but can be patched to
A: 48K
C: X-USB : 37
use any other available signal on the audio engine
sends main
as well, including mix bus/sub group outputs.
Changes of the Channel Source can be made on the
Preamp Config page.
Input Channels 17-32 are pre-configured
Ins Post
to AES50 A inputs 1-16, so that connecting an
Insert
S16 stage box to port A will automatically feed
OFF
InsFX 1L the channels.
InsFX 1R
InsFX 2L
Aux Return Channels 1-8 are pre-configured
InsFX 2R
InsFX 3L
to use the 6 aux input signals, and the two USB
InsFX 3L
playback outputs, but can be patched to use any
other available signal of the console as well.
Ins Pos Insert
PRE InsF
FX Return Channels 1L-4R control the 4 stereo
Insert Connect
output signals of side-chain FX 1-4.
Matrix Channels 1-6 are fed exclusively by
MAIN LRC and Mix Bus 1-16 signals. The processing
MyProj.prj
Scene01
steps include (in this order):
sends main
Insert point (swappable between post-EQ and
•
pre-EQ operation)
6-band fully parametric EQ
•
Insert Post
Compressor/expander (swappable between
•
Insert
post-EQ and pre-EQ operation)
Ins 01
Ins 02
Ins 03
Effects Processing 1-8
Ins 04
...
FX 01
The X32 COMPACT console contains eight true-
FX 02
stereo internal effects engines.
Insert Pos. Insert
FX 1-4 can be configured as side chain or insert
•
Pre
effects, while FX 5-8 can only be used in insert
Insert Connect
points of channels or buses
The returns of side chain FX 1-4 can always be
•
controlled using the 6th bank (layer) of the input
channels - Effects Returns. Note that the return
signals of FX 1-4 have separate faders for left
and right
The FX Home screen allows selection of the
•
FX 1-4 input sources and selecting the effects
type/algorithm for each of the 8 FX slots of the
virtual rack
The subsequent tabs FX 1-FX 8 of the FX screen
•
allow editing all parameters of the chosen
effects processor