Connecting The Center Speaker To The Subwoofer; Start-Up And Operation; Select The Center Signal On The Subwoofer; Technical Data - Loewe Satellite Centerspeaker I Compose Bedienungsanleitung

Connection
Connecting the Center speaker to the
subwoofer
Thread the speaker cable through the hole in the enclosed speaker cover (A).
One of the two wires of the speaker cable ( C ) is marked black. Connect these
black marked wires with the black terminal on the subwoofer ( wiring according
to the picture on the right) and the black terminal (B) on the speaker. Connect
the unmarked wires with the red terminals. Then press the cover (A) back onto
the satellite speaker.
Satellite
speakers
Front
left
Power OUT
R
Surr.
L
R
Front C
L
Center to
Sat
Slave
System connector
Master
Subwoofer
Surround
left
- 14
B
C
A
Front
right
Center
ON
OFF
Bass Intensity
Min. Max.
Phase
Line IN
TV
Right Subw. Left 0 180
Surr.
Front
Right Center Left
230V~50/60Hz
Surround
right
Position the speakers as described on page 11 or mount the satellite speakers
on the wall with the wall holder or on the optional stand as described in the
respective installation instructions. Before beginning with start-up and opera-
tion, make sure that all the cables are connected correctly.

Start-up and operation

Select the center signal on the subwoofer

Switch not pressed = center via satellite speaker.

Technical Data

Satellite loudspeakers
Dimensions satellite loudspeakers in cm
Speaker
Stand
Weight satellite loudspeakers in kg without/with stand
Fitting
Load capacity
Impedance
Transmission range
Sound pressure
W 6,2 H 15 x D 6,2
Stand Ø 20 x H 100,5
0,7 / 3,3
2x broadband, paper diaphragm, Ø 55mm
30 W (sine) / 45 W (max. music)
150 Hz–20 kHz ± 3dB
86 dB (1w/m)
8 Ohm