General Information; Connecting The Transmitter - Clatronic sls 693 Bedienungsanleitung

Correct connection is as follows:
When you have connected all loud speakers and devices
as described you can insert the mains plug of the sub-
woofer into a correctly installed 230 volt, 50 hertz power
socket.
Optional Connection of the Rear or
Front Loudspeakers to the Transmitter
1 SCAN
Button for activating the channel search
2 Standby control lamp
3 AC 230 V / 50 Hz
Mains lead
4 R OUT / L OUT (RIGHT/LEFT)
Loudspeaker output (right/left)
5 POWER ON / OFF
On/off switch
05-SLS 693 Neu 25
6 DC 5V IN Connection socket
7 AUDIO IN
3.5 mm jack socket audio input
8 FREQUENCY SELECT Button
For resetting the channel
9 POWER Control lamp
10 ON / OFF
On/off switch
11 VOLUME
Volume control
12 Foot

General Information

• The audio signals are sent from the transmitter to the
receiver. The range within buildings is approximately
30 m. The range may be less, depending on the
ambient conditions.
• The audio signals are transmitted in the 2.4 GHz
range.
• Compression-free high sound quality with 0.5 ms
delay time.
• The audio signals are processed digitally at a samp-
ling rate of 44.1 KHz and 16 bits.
• If the transmission is affected by interference or poor
reception, the device activates the muting function
(see section on "Poor Reception Quality").

Connecting the Transmitter

Transmitter
Connect the 3.5 mm jack plug to the AUDIO IN socket
•
on the transmitter.
Then connect the cinch plugs to the AUDIO OUTPUT
•
REAR RIGHT/LEFT of the subwoofer.
Note: It is possible to connect the front loudspeakers
instead. In this case connect the cinch plugs to the
AUDIO OUTPUT FRONT RIGHT/LEFT connections.
• Insert the power pack into the 5V DC connection
provided and then into a correctly installed 230V/50Hz
power socket.
25
09.02.2006, 10:34:31 Uhr