Specifications; Warranty; Troubleshooting - Vivanco CHH 500 Bedienungsanleitung

GB
Charging the batteries
1. Switch off the RF headphone.
2. Connect the charging cable connector of the transmitter and the charging cable
connector of the RF headphone to the charging cable.
3. The batteries will be charged automatically and the power-on lamp of the RF
headphone turns to red.
4. Attention: Charge the batteries for 24 hours before you first use them to achieve full
performance.
The RF headphone has a protective charging function for longer battery life. It takes
10 hours to charge the batteries. Disconnect the cable. You can now listen to music
at an average volume for another six hours.
Using different batteries
The RF headphone can also be used with other standard AAA micro batteries or non-
chargeable 1.5 V batteries. Standard AAA micro batteries cannot, however, be charged via
the devices.
Disposing of the batteries and battery packs
Consider the environment when disposing of the batteries or battery packs, which must
not be thrown away with domestic rubbish. Do not use old and new batteries or different
battery types simultaneously. Remove batteries from the device if it is not to be used for a
long time.

Specifications

No. of channels:
Frequency range:
Modulation:
Power supply:
Transmitting power:
Operating temperature:
Subject to alteration.
Trouble-shooting
If your device should not function properly, please proceed as follows:
1. Using the following table of malfunctions, try to find and correct the fault.
2. Read the corresponding section in these instructions carefully.
3. Look on the Internet at www.vivanco.com to see whether the fault and its correction
are described.
4. Ask your dealer.
5. Call the telephone hotline 01805 / 40 49 10 (€0.12/min.) for Germany. You will find
contacts for Europe at www.vivanco.com
10
8
2.400 – 2.483 GHz
FSK
Transmitter: AC adapter 12 Volt/ 300mA
RF headphone: 2x micro AAA batteries
max. 10 mW
5 - 40° C
GB
Problem Possible cause
No transmission / no sound Devices are outside range
Batteries are empty
Connection cut off
Incoming signal not loud enough
Interference can be heard during Interference on channel
transmission
Batteries are almost empty
Devices are on outer margin of
range
Position of transmitter
Interference caused by microwave
or W-Lan (WiFi)
Licence
This Vivanco RF product conforms to the European R&TTE directive for RF systems in
harmonised frequency ranges. These systems may be sold and operated in the EU and in
EFTA countries.
Operation is not permitted in all countries not named.
The declaration of conformity is included at the end of this manual.

Warranty

The warranty period is 12 months from the date of purchase.
Hotline
Contact Germany:
European contacts can be found at http://www.vivanco.com.
Solution
Reduce distance between devices.
If ordinary batteries are used, replace them.
If you use the supplied batteries, charge them.
Check that all cable connections are correctly made.
Increase the volume of the incoming signal (music, etc.). The
automatic cut-off switches off transmission when the signal is
too weak or missing.
Change the channel using the Auto-Tuning function.
The batteries are almost empty and need to be replaced. If you
use the supplied batteries – charge them.
Transmitter and RF headphone are too far apart. Bring the RF
headphone closer to the transmitter.
In some cases it may be necessary to place the transmitter
somewhere else or higher.
Place the transmitter at least
1 m away from the microwave or W-Lan (WiFi).
Telephone hotline 01805 / 404910 (0.12 € / min.)
or http://www.vivanco.de.
11