Clatronic wk 2703 Bedienungsanleitung Seite 24

Please read these operating instructions carefully and keep them in a safe place. Before
using for the fi rst time, boil fresh water at least twice in the appliance. Use only water without
any additives or ingredients.
1. Place the machine on a fl at surface.
2. Open the kettle by pressing the button on the lid. Then fi ll in some water. The water level
can be read off using the water level indicator on both sides of the kettle. Please do not
overfi ll the kettle.
3. Close the lid.
4. Place the kettle fl ush on the base.
Electrical Connection
1. Check whether the mains voltage supply that you intend to use is the same as that of
the kettle. For information on the voltage supply of the kettle, please see the identifi cati-
on plate on the base.
GB
2. Only connect the machine to a properly installed 230 V, 50 Hz safety socket.
3. Switch the kettle on with the switch in the handle. The control lamp lights up.
4. The kettle switches off automatically when the water has boiled. Now disconnect the
kettle from the mains power supply. Always hold the lid closed when pouring the water
out. Beware of scalding!
• Always pull out the plug from the socket before cleaning!
• The exterior of the machine should be cleaned, if necessary, with a slightly damp cloth
without additives.
• In order to clean the kettle you can remove the lime fi lter by pulling the fi lter upwards.
Now you can clear the fi lter of lime residues under running water.
• The frequency of the decalcifying operation depends on the hardness of the water and
on how often the appliance is used.
• If the machine switches off before the water boils, it probably needs to be decalcifi ed.
Please do not use vinegar but a commercially available decalcifi cation agent on the
basis of citric acid. Only use the quantities stated in the instructions.
24
05_WK 2703 NEW GR fuer F 24
First Use of the Machine
Use
Cleaning
Decalcification
29.03.2006, 9:03:11 Uhr