Cleaning And Storage - Ventus W164 Handbuch

Single press [0] button. The reading will reset to zero and the "TARE" icon will remain on the upper display.
-
Now you can add your additional ingredient. Only the weight or volume of the last ingredient added in measured. Continue
above procedure to build up different ingredients for your recipe.
NOTE: The tare function only operate when the cup is placed on a flat surface
Reversing the Tare Function
Right after the tare function has been performed and the display is showing "0" reading with the "TARE" icon appeared, you
can press [0] button to resume the original weight or volume reading just before the tare function and the "TARE" icon will
disappear.
NOTE: The reverse tare function only operate when the cup is placed on a flat surface
IMPORTANT NOTE: It is easy and convenient to mix different ingredients in the cup. However when mixing your ingredients,
you should avoid pressing down the bottom of the base where the sensitive weight scale components are located.
Excessive force applied to the base of the cup may permanently damage the scale inside and provide inaccurate reading.
FAULT MESSAGE DISPLAY
UnSt: Unstable
The scale is unstable and the unit will turn off automatically. Place the cup on a flat table and
turn on the unit again by pressing [0] button once.
Err: Error
The scale is overloaded. The weight or volume in the cup exceeds the maximum display
range (refer "Specification" section)
CALIBRATION
To ensure accurate measurement, you are suggested to check the weight of an empty cup every time you first turn on the
unit. It should read 0 gram (or oz) for your empty cup.
Calibration for the cup is needed ONLY when the reading of your EMPTY cup is higher than zero (gram, oz, cups, fl oz or
ml). The calibration process will reset the reading to zero for the empty cup.
To calibrate,
1) Make sure the transparent cup is attached to the base.
2) Make sure the cup is empty. Clean the unit with a dry cloth to remove any excess liquid on the cup.
3) Turn on the unit by a single press of the [0] button.
4) Make sure the cup is placed steadily on a flat surface. Hold [0] for 6 seconds until "CAL" flashes. Do not touch or move
the cup when "CAL" is flashing.
The display reading will show "0" and the calibration is completed

CLEANING AND STORAGE

The transparent cup is dishwasher safe and it is detachable for cleaning. Press the button below the handle to unlock
-
and detach the cup from the base
- Only clean the transparent cup with cold or warm water together with optional mild cleaning detergent. Do not use
boiling water to clean the transparent cup as it can withstand up to 70C maximum.
- Detach the transparent cup and use damp cloth to clean the base and the handle.
Never immerse the base & handle in water or put into dish washing machine for cleaning
-
7