Ghibli 45M45 Gebrauchsanleitung Seite 59

8.1.c - Using the machine
- After having activated the machine and
chosen the desired cycle typology, start
the cleaning operations: use the handle-
bar unit (1) to push the machine or use
the proper commands (2) (buttons or le-
vers) to activate the drive mechanism (for
models which are equipped).
N.B.:
To avoid damaging the floor, do not use the
machine in a fixed position with brush rota-
tion activated
N.B.:
The correct way of cleaning and drying the
floor is to move the machine forwards. Mov-
ing the machine backwards damages the
blades as well as not allowing correct aspira-
tion of the water present on the floor.
- If necessary, adjust the quantity of wash-
ing water using the tap (3).
- Check the status of the battery charge by
the indicator (4).
8.1.d - End of use and switching off
- Once the cleaning operations have been
completed, do not shut off the machine
immediately: use switches (5) and (6) to
deactivate water dispensing and brush
rotation and continue with the suction unit
in function in order to eliminate any re-
sidual liquid on the floor. When finished,
press the switch (7) to shut off the suction
unit.
- Lift up the floor squeegee (8) by lifting up
the lever (9), hooking it in the specific fix-
ing clip (10).
- Lift up the brush by pressing the pedal
(11) as far as it will go, fitting it in the des-
ignated slot.
WARNING:
Always lift up the squeegee at the end of
cleaning in order to prevent the deforma-
tion of the rubber blades.
- Turn the key (12) to its "0" position to shut
off the machine.
10
11
7
12
7
12
EN-19
9
8
6
5
6
5
4
Fig. 13
EN
2
1
3
4