Maintenance - EFBE-SCHOTT OT 1003 CF Gebrauchsanleitung

Fax +32 2 359 95 50
put the extension ring on the glass bowl and then close the
lid again.
USE
•
When using for the first time, clean the appliance with a damp cloth and wipe dry.
•
Plug the unit into an earthed wall socket.
•
Put the food in the oven on the rack or baking tray at the desired height. Make sure that
the foods are at sufficient distance from the lid/heating fan. Close the lid.
•
Select the desired time and temperature thanks to the knobs of the control panel on the
lid. The red power indicator lights up as soon as the appliance is switched on. The green
control light lights up when the appliance is heating.
•
Turn the mechanical timer (7) to set the desired cooking time. You'll hear a signal when
the cooking time has elapsed. The appliance will switch off automatically. The pilot lights
will go out.
•
If you want to stop before the selected time is over, place the timer in the "0" position.
•
Always carefully open the lid using oven gloves fittingly. Caution! Do not touch the hot
parts, especially the metal shaft from which the hot air is blown out. Risk of burning!
•
Remove the food carefully using appropriate utensils.
•
After use, remove the plug from the wall socket.
SETTINGS
THERMOSTAT
You can adjust the temperature steplessly up to 250°C.
TIMER
You can choose a desired cooking time up to 60 minutes. If you wish to set the timer to less
than 5 minutes, turn it to a position higher than 5 minutes first and then set it back to the desired
time.

MAINTENANCE

Before cleaning, unplug the appliance from outlet and allow it to cool down.
Cleaning removable parts
Remove the accessories and the glass bowl and clean these parts in soapy water.
Please take care to put back the protective cap on the food tumbler before use.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
13
Assembly page 13/28
TKG OT 1003 CF – 100622