Technical Information - Bestron Dbs827 Gebrauchsanweisung

user's instructions
operAtion - seal bags
A roll of seal bags is included in your new bag sealer. This instruction manual describes the sealing steps
for seals bags, which are already sealed on two sides. Please note that not all seals bags are suitable for
using with a bag sealer.
operAtion - using the bag sealer
1. Plug into appropriate outlet.
2. Open the lid and pull a piece of foil (slightly lager than required) out of the equipment. Use no more
than 29 centimetres foil at a time, otherwise you cannot seal the last seam.
3. Now close the lid and push down evenly with two hands on both sides. The green indicator light will
illuminate. Hold the lid down until the light extinguishes. The bag is now securely sealed and separated
from the roll of seals bags inside the appliance.
4. Now fill the bag through the open unwelded side, taking care that the seams area remains free, so that
the welding process is not interfered with the substance being filled into the bag. When filling the bag
with liquids, only fill half of the bag. Make sure the appliance does not absorb any liquids.
5. Smooth the open side of the bag, open the lid again and place the foil over the sealing wire into the
appliance. Repeat the welding process as previously described. After the green indicator light has
extinguished, that side of the bag will also be securely sealed and excess foil can be easily removed.
operAtion - Air pump function
This device is fitted with an air pump to remove surplus air from the foil bag. After this you can easily seal
the bag.
1. Place the open side of the seal bag in the sealer, so that the air pump is inside the seal bag.
2. Suction starts as soon as you lightly press the centre of the lid. Only the red lamp will light up.
3. As soon as sufficient air has been sucked out, use both hands to press both sides of the lid. Suction
stops, the green control lamp lights up and sealing commences.
4. Check whether the bag is sealed properly. If not, repeat the sealing.
5. After use remove the plug from the wall socket.
Between each sealing application wait at least 1.5 minutes.
cleAninG & MAintenAnce
1. Before cleaning your bag sealer, always make sure that the plug has been remove from the mains
supply socket.
2. Wipe the outside housing of the bag sealer with a damp cloth. For safety reasons, the appliance
should not be immersed into liquids.
3. Do not us harsh or abrasive cleaners.

technicAl inforMAtion

Type: DBS827
Output: 150 W
Power supply: 230 V ~50 Hz
the enVironMent
• Dispose of packaging material, such as plastic and boxes, in the appropriate waste containers.
• When this product reaches the end of its useful life do not dispose of it by putting it in a dustbin;
hand it in at a collection point for the reuse of electrical and electronic equipment. Please refer to
the symbols on the product, the user's instructions or the packaging.
• The materials can be re-used as indicated. Your help in the re-use, recycling or other means of
making use of old electrical equipment will make an important contribution to the protection of the
environment.
• Contact your municipality for the address of the appropriate collection point in your neighbourhood.
13