Werbung
Verfügbare Sprachen
Verfügbare Sprachen
29. Children should be supervised to ensure that they do not play with the appliance.
30. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified person in order to avoid a hazard.
WARNING:
Important:
If the suction opening of the unit, the hose or the tube is blocked, switch off the vacuum cleaner
and remove the blocking substance before you start the unit again.
1. Do not operate the vacuum cleaner too close to heater or radiators.
2. Before inserting the power plug into the wall outlet, make sure that your hands are dry.
3. Before you start the unit, make sure to remove large or sharp objects that might damage the
dust tank and hose.
4. When pulling out the power plug from the wall outlet, pull the plug not the power cord.
5. Do not use without all filters in place.
6. When using, if you learn of squeak from the cleaner, it must be suction appears to be
reduced, so you must stop (make sure the cleaner is not plugging), then clean the all air filter.
WARNING :
Hold the plug when rewinding the cord. Do not allow the cord to whip when rewinding.
Use and function
Assembling vacuum cleaner
Note:
Always remove the power plug from the wall outlet before assembling or removing accessories.
1. Attaching the Flexible Hose into the vacuum connect the flexible hose into the air intake duct,
push in until you hear a "click" sound, indicating it is in its locked position.
2. Fitting the tube to the curved wand/hose extension. Push the tube into the curved
wand/hose extension.
3. Fitting the floor brush to the tube. Push the tube into the floor brush. Adjust the tube to the
desired length.
Button function introduction
Note:
Once all attachments are in place, unwind a sufficient length of cable and insert the plug into the
wall outlet. A yellow mark on the power cord shows the ideal cable length. Do not pull the
power cord beyond the red mark.
1. Insert the power plug into the wall outlet.
2. Press the power on/off button located the unit to turn the vacuum cleaner " on ".
3. To rewind the power cord, press the cord rewind button with one hand and guide the power
cord with the other hand to ensure that it does not whip causing damage or injury.
8
Werbung
