Wir 100 Remote Control; Registration Of One Wic 01M; Registration Of Multiple Unregistered Wic 01M In One Remote Control - Window Master WIC 01M Montageanleitung

WIR 100 Remote control

The supplied remote control, the WIR 100, is a one-way remote control that can be configured to operate one single
product or several products simultaneously. WIR 100 is an io-homecontrol
®
homecontrol products.
When only one-way remote controls are used it is strongly recommended that only ONE product is connected to the WIC
01M. This can be a window opener or a sun screen product, e.g. a venetian blind or a roller shutter.

Registration of one WIC 01M

The setup of one WIC 01M is described here.
Connect WIC 01M to mains supply (UK version has a UK plug).
1.

WIC 01M is now in the registration state. The remaining
steps must be completed within 10 minutes.
Pull out the strip from the bottom of the remote control.
2.
Use a pointed object to press the reset-button for 1 second.
3.
At this point the WIC 01M is registered and can be operated by the remote control. If the ten minutes were exceeded the
system has to be reset in order to be reconfigured. Disconnect and reconnect the mains supply to the WIC 01M in order
to do this.

Registration of multiple unregistered WIC 01M in one remote control

The setup of multiple WIC 01M for operation by one remote control is described here.
NB: All WIC 01M must be connected to the same type of product, e.g. window openers or
blinds.
Connect all WIC 01M to mains supply (UK version has a UK plug).
1.

Every WIC 01M are now in registration state. The subsequent steps
must be completed within 10 minutes.
Pull out the strip from the bottom of the remote control if this is not already done.
2.
Use a pointed object to press the reset-button on the rear side of the remote
3.
control for 1 second.
Now it is possible to operate all of the windows or sun screen products attached to a WIC 01M simultaneously from one
remote control.
®
product i.e., it is compliant with other io-
6