Using Your Appliance; Description Of The Control Panel - DeDietrich DHD697 Betriebsanleitung

EN

3 / USING YOUR APPLIANCE

DESCRIPTION OF CONTROL PANEL
•
Model DHD697 (fig. 15)
A) Turns the LIGHTS off.
B) Turns the LIGHTS on.
C) reduces the motor speed until reaching
minimum. If pressed for about 2", it stops the
motor and storse the speed.
D) drives the motor (calling the last speed used)
and increases the speed until reaching maximum.
L Display:
- signals the running speed.
- signals the filter alarm (with motor off) by displaying the central segment for 30".
- signals Timer activation with a flashing number.
E) activates the TIMER (when the motor is running), so that the hood stops automatically after 5'. Also
Zero-sets hour metering when the Filter Alarm is active (motor OFF).
FILTER ALARM
Displayed for 30" when the motor is off:
After 30h of operation, the central segment lights up on the display; It indicates that the grease filters
need to be cleaned.
After 120h of operation, the central segment flashes on the display; It indicates that the grease filters
need to be cleaned and the charcoal filters replaced.
After cleaning the grease filters (and/or replacing the charcoal filters), restart the hour counter (RESET)
by pressing the key E during display of the filter
alarm.
Models DHD497 / DHD790 (fig. 16)
A) Turns the LIGHTS off.
B) Turns the LIGHTS on.
C) Decreases speed down to minimum speed. If
pressed for 2" the motor is turned off.
D) Activates the motor (calling the last speed
used) and increases the speed until reaching
maximum..
E) FILTER ALARM/TIMER RESET: when pressing the key during display of the filter alarm (motor off)
it resets the hour counter. When pressing the key when the motor is running, the TIMER is activated
and the hood will automatically be switched off after 5 minutes.
L1) The 4 green LEDs indicate the running speed.
L2) When the LED is red (motor off) it indicates the FILTER ALARM. When the LED is green (flashing)
it indicates that the TIMER has been activated with the key E.
FILTER ALARM
After 30h of operation, the LED L2 turns RED. It indicates that the grease filters need to be cleaned.
After 120h of operation, the LED L2 turns RED and flashes; It indicates that the grease filters need to
be cleaned and the charcoal filters replaced.
After cleaning the grease filters (and/or replacing the charcoal filters), restart the hour counter (RESET)
by pressing the key E during display of the filter alarm.
Tip
This guide to installation and use is valid for several models. Minor differences in
details and fittings may emerge between your appliance and the descriptions provided.
27
fig. 15
fig. 16