Connecting The Amplifier - Clarity ECE125 Bedienungsanleitung

2859 CE125 guide 17-10-2003
Parts of the amplifier
•
A Battery cover
•
B AAA batteries
•
C Battery indicator (red)
•
D Connection to telephone handset
•
Connection to telephone
E
•
F Boost button (for additional amplification)
•
G Boost indicator (green)
•
H Tone control

Connecting the amplifier

Installing or replacing batteries
• • •
(see , and )
A B C
1. When you install or replace batteries, first
disconnect the amplifier ECE125 from the telephone.
•
2. Open the battery cover A and fit the
•
batteries as indicated B .
•
3. Close the battery cover properly.
A
4. If the batteries are flat, the red light
will not illuminate.
Replace the batteries as soon as possible.
The indicator will only illuminate if the amplifier
is in use.
N.B. You need 2 AAA batteries for this amplifier.
Battery life ranges from two to six months,
depending on the frequency of use of the amplifier
and the type of battery. On purchase, we
recommend alkaline batteries.
4
10:44 Pagina 10
Connecting the telephone handset
•
(see )
D
1. Disconnect the telephone flex with handset
from your telephone by removing the
modular plug from the telephone.
2. Connect the handset to the amplifier.
Connect the telephone flex via of the
opening at the bottom of the amplifier
Connecting the amplifier to
the telephone (see
1. Plug in the connection flex
in the top of the amplifier
end in the telephone (where the handset was
previously connected).
2. Pick up the handset and check whether you
hear a dial tone.
The Clarity™ Amplifier ECE125 cannot be
•
C connected to a telephone with the dialling
mode installed in the handset.
GB
•
D .
•
)
E
•
with one end
2
•
E and the other
5