Part Description - Di-soric LAT 61 Serie Bedienungsanleitung

● Make sure that the length of signal and power lines connected to the
product is less than 30m in order to meet the CE marking require-
ments.
● Attach a ferrite core to the head cable as shown.
30mm max.
Warming Up
● Allow the product to warm up for at least 30 minutes after turning on
the power to ensure good performance.
Environment
● Mount the sensor head on an aluminum or steel plate with a minimum
surface area of 200cm if the ambient temperature is 40°C or higher.
2
When installing two or more sensor heads in parallel, mount each
sensor head on an aluminum or steel plate with a minimum surface
area of 200cm and make sure that the ambient temperature does not
2
exceed 40°C.
● The life of the semiconductor laser depends on the ambient tempera-
ture during use. When using the product near a heat source, take
measures to keep the ambient temperature of the sensor head as low
as possible.
Mount the sensor on a device that allows heat to dissipate because
the sensor itself also generates heat.
● Keep the emitter surface and the receiver surface clean. Prevent light
as dust and dirt from contaminating the surface. When cleaning these
parts, wipe them off using a soft lint-free cloth or lens cleaning paper.
● Install the sensor head at a location where external light (such as
sunlight or light which has the same wavelength as the laser beam) do
not enter the receiver. If high accuracy is required, install a light shield
plate or something similar around the sensor head.
● Do not use the product underwater or in the rain. Although the sensor
head has an IP67 degree of protection, the connectors are not dust-
proof, waterproof, or corrosion-resistant.
● Do not use the product in dusty places or in places that are exposed to
tion or impacts.
4

Part Description

2
1
3
4
5
8
6
7
9
1. Laser Indicator (LASER)
2. Alarm Indicator (ALARM)
3. OUT1 Indicator (OUT1)
4. OUT2 Indicator (OUT2)
5. OUT3 Indicator (OUT3)
6. [ENTER] Key
5
Wires
Analog output wires
Name
A (V) Analog voltage output
AGND Analog ground
A (I) Analog current output
AGND Analog ground
I/O terminal wires
Name
OUT1 Judgment output 1
OUT2 Judgment output 2
OUT3 Judgment output 3 or alarm output
TM Timing input
MI Multifunction input: Zero set, zero set
OFF, reset, change memory, teach,
save, and laser control
-
NP NPN/PNP type switching input
+V 24V DC input for power supply
0V Power supply ground
2
10
12
11
7. Digital Display
8. [UP] Key
9. [DOWN] Key
10. Emitter
11. Receiver
12. Warning Label
Function
Shielded single
conductor
Shielded single
conductor
Function
Black
White
Gray
Pink
Violet
Pink/ Violet
Brown
Blue
Wire color
Black
Gray
Wire color