Installation; Installation Skoda Nexus / Vw Mfd 2 - IMU 1424 Bedienungsanleitung

12

Installation

Installation SKODA Nexus / VW MFD 2:

1. Remove and disconnect the head unit.
E
2. Connect the wires with loose ends from cable kit as follows:
N
G
White (CAN high)
L
Green (CAN low)
I
S
Black (ground)
H
Red (+12V, permanent)
3. Connect the black plug from cable kit with the jack in the rear
(marker) of the head unit.
4. Connect the device remote cable kit and the vehicle cable kit (3 pin plug) via the enclosed Y-cable with the
remote control input from the video device. Due to the Y-cable, the original IR eye can be used further on.
5. Connect RCA jacks - audio right (red), and audio left (black) of the cable kit with the video source.
6. the pink loose gives +12V out (Remote) to switch on the rear view camera (Information provided by the
camera manufacturer).
7. if the navi doesn't switch automatically to the rear view camera by the reverse gear, the brown loose wire
must be connected to reverse signal (+12V) of the car.
8. Connect RCA jacks - A: video (CVBS), B: video (CVBS rear view camera) with the video source.
Connection with the video source should only be done with high quality RCA video cables otherwise the
picture quality could be bad, caused by a weak video signal.
9. Refit the head unit.
Pin 9
Pin 10
Pin 12
Pin 15
®
Copyright © by Audiotechnik Dietz Vertriebs-GmbH ● Germany
Rev 1, Stand: 09/ 2009
®
MOST connector at head unit