Programming The Remote Control - Becker Centronic SensorControl SC811A Betriebsanleitung

Assembly and Operating Instructions

Programming the remote control

Note
Before the SC811A can be programmed, a master transmitter (e.g.
SWC441A) has to be programmed into the radio receiver for sun pro-
tection systems, and the limit stops have to be programmed.
It is possible to program up to 3 sensors into the radio receiver for sun
protection installations.
Caution
Before programming the master transmitter, always ensure that there
are no obstructions in the immediate operating area of the sun protec-
tion system, as the system may extend unexpectedly.
Programming the SC811A
The SC811A features an integrated radio transmitter.
a) Press the programming pushbutton of the master transmitter until acknowl-
edgement is given by the receiver.
b) Press the programming pushbutton on the SC811A until the receiver confirms
the signal setting.
c) Now press the programming pushbutton on the new SC811A to be pro-
grammed once more.
The receiver will indicate when the learn process has been successfully com-
pleted.
The maximum radio range is up to 15 m indoors and up to 150 m in the open.
16