Replacement Parts; Accessories - KASK Sports Helmets Gebrauchsanleitung

GB
HELMET ADJUSTMENT: Put on the helmet by rotating the rear
dial (clockwise to tighten and counter-clockwise to enlarge)
and/or simply (only for the versions with this system) by approa-
ching the two elements of the fast closing system until you
obtain the desired fit (Fig. 2). Position the size adjustment
system in the zone of the nape (Fig. 3), inclining it and (only for
the versions with this system) regulating it in height. Close the
strap by inserting one side of the buckle into the other, until you
hear the blocking mechanism click shut (Fig. 4a/b). Tug to check
that the buckle is secure. Adjust the length of the neck strap to
fit the helmet securely to your head. The rubber ring should be
placed at the end of the strap to keep it from dangling. Adjust
the side spacer, moving it along the strap until it reaches the
desired position (Fig. 5). To remove the helmet, open the
neckstrap by releasing the lever of the micrometrical adjustment
buckle (Fig. 4a), or by pushing both side buttons on the snap
buckle at the same time (Fig. 4b).
REPLACEMENT PARTS: If necessary, contact the dealer or
contact the manufacturer directly. None of the original compo-
nents of the helmet may be changed and/or removed without
the manufacturer's approval. The helmet should not be modified
to attach any accessories except for those described below:
ACCESSORIES: Winter padding - sun visor - ace shield -
sahariana. Check with the dealer or manufacturer whether the
accessories listed above are available. If they are supplied
with the helmet, follow the mounting instructions that come
with the accessory. Only accessories approved by the
manufacturer should be used.
CLEANING: Clean the helmet (and sun visor, if applicable) only
with water, neutral pH soap, and a soft, clean cloth, allowing it
to air dry at room temperature. The inner lining should be