Maintenance; Warranty Limit; Limits Of Manufacturer Liability - Studer aj series Montageanleitung

STUDER INNOTEC

Maintenance

The inverters of the AJ series do not need
any special maintenance. The casing may
be cleaned with a damp cloth (not wet).
In the case of malfunction, the inverter
should be sent back to the manufacturer
for control in its original packing.
Before sending the inverter, check the
table above.
The battery is loaded and is in accordance
to the inlet nominal tension of the device.
The consumer devices do not have any
defects or overload for the inverter.
Should you contact your salesperson, note
the following points before calling:
(you will find this information on the label
underneath the inverter)
- Series number
- Power of the inverter
- Inlet nominal voltage of the inverter
Before sending back the inverter, do
take care that it is well packed. The
inverter must be in a stiff carton box
and be well protected on all sides by
mean of an anti-shock and isolating
layer of min. 5cm thickness.
The damages occurring during the
transport are not
warranty.

Warranty limit

The warranty period is 2 years.
It will be considered void if the unit has
suffered any physical damage or alteration,
either internally or externally, and does not
cover damage arising from improper use
like:
− Reverse of battery polarity
− Inadequate input voltage (over voltage)
− Back-feed of the inverter output by public
network, generator or any other source.
covered by the
AJ V2.2
− Mechanical
shock
specially by transport due to an
inadequate package.
− Contact with liquid or oxidation by
condensation
− Use
in inappropriate
(dust, corrosive vapour, humidity, high
temperature,...)
This warranty will not apply where the
product has been misused, neglected,
improperly installed, or repaired by
anyone other than STUDER INNOTEC
or a company authorised by STUDER
INNOTEC. In order to qualify for the
warranty, the product must not be
disassembled or modified.

Limits of manufacturer liability

STUDER INNOTEC cannot control the
installation, use and maintenance of the
inverter. Thus, we are not responsible
for damages, costs or losses resulting
from an installation which is not in
accordance with the regulations or
inappropriate use or maintenance.
The customer is always responsible for
the use of the inverters STUDER
INNOTEC.
This device has not been designed and
is not warranted for use in life support
apparatus or any other critical device
with potential risks of important harm to
people or to the environment. We do not
accept any responsibility
violation of patent rights or other third
person rights resulting from the use of
the inverter.
STUDER INNOTEC keeps the right to
modify their products without previous
notice.
AJ
or deformation
environment
for any
8/30