Connection - Studer aj series Montageanleitung

STUDER INNOTEC

Connection

The connection of the inverter should be
done with utmost care. First connect the
consumer devices so as to prevent any
further contact once the 230 V voltage is
present. The
connection's description, is either under
one side of the inverter or onto the cable
connection side. Installation is to be made
only by authorised persons.
Connecting the consumer devices
The AJ inverter is supplied with a 230 V
cable for the consumer devices. This
connection must be done observing the
colours:
Yellow-green: earth
Brown: phase
Blue: neutral
Once the consumer
connected, make sure that they are turned
off before connecting the battery
technical data
devices
Note
An Inverter constitutes an independent
power supply from the grid and could be
considered in the same way as a
generator set. The phase and the
neutral
voltage in between the phase and the
neutral is 230V. An appropriate divisor
establishes a 115V voltage in between
neutral and earth, and the phase and
earth.
prescriptions or particular requirement,
(example: use of a ground fault detector)
a true neutral may be established by
connecting the neutral and the earth
wire together. The so connected point,
may be connected with an existing
earth: earth of building; the chassis of
vehicle or the hull of ship.
Equivalent schema
and
Connecting the battery
Once
connected,
installations instructions of the 230V has
been followed with utmost care before
are
connecting the battery.
AJ V2.2
are not differentiated.
According to
the consumer
make sure
AJ
The
the local
devices are
that the
4/30