Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
STUDER INNOTEC
Introduction
The sine wave inverters of the AJ series
have been designed to meet industrial and
domestic needs. They meet the highest
requirements
of
reliability.
Any
device
designed
electrical network of 230 V 50 Hz can be
connected to them (up to the nominal
power of the inverter).
The AJ series is the perfect source of
voltage in any place where the public
network is not available.
This document is an essential part of the
inverter and must always be carried with it
and be at the disposition of anyone
working on the installation.
Should you have any doubt or question, do
not hesitate to contact your specialist
salesperson who will give you the best
advice.
Warning
A deficient assembly could result in
damage to the device, cause function
failures or potential damage to the users.
The working device generates a high
voltage which might be lethal in case of
contact. So, any manipulation of the
inverter must be carried out with utmost
care.
THE OWNER MUST NOT MANIPULATE
ANY PIECE INSIDE THE INVERTER.
Opening the inverter or using it incorrectly
will result in the immediate loss of the
warranty.
No current or tension generating device
(public grid, generator,...) may be con-
English description
comfort,
safety
for
the
public
AJ V2.2
nected to the outlet of the inverter
because
destruction.
The inverter AJ is to be used only with a
and
lead battery. As for the use of batteries,
follow the manufacturer's instructions.
Installation
The AJ sine wave inverter is an
electronic
caution must be taken when installing it:
Place where the inverter is to be
installed:
Out of reach of unauthorised persons,
specially children.
In a dry place (max. 95% humidity), and
in any case with no condensation.
Not directly on top of the batteries.
Ventilation must be free, and a space of
10 cm. on each side is needed for good
evacuation of the internal heat.
Fitting the inverter
The inverter is fitted by screws (max.
4mm for AJ 275-AJ 1300 or max. 8mm
for AJ 2100 and 2400) using the four
holes provided. The fitting screws are
not supplied with the inverter. It may be
fit into any position.
this
could
result
device,
for
which
AJ
in
its
some
3/30
Werbung
Inhaltsverzeichnis
