Canton Digital Movie 50 Bedienungsanleitung Seite 27

English
Problem Possible cause
No playback via 1. there is no connection between the
Bluetooth ® . DM System and the mobile end device.
2. the mobile end device is paired but
no playback takes place.
3. You are out of range.
52
Solution
1. Connect your mobile end device as described.
2.1. the mobile end device must be connected again.
2.2. Set the volume on the mobile end device to maximum.
2.3. increase the volume of the DM System.
2.4. ensure that interference sources like a WlAN router
or laptop are not set up in direct proximity of the DM
System.
2.5. Concurrent operation of WlAN and Bluetooth ®
connection from a mobile end device is not possible
without interferences in most cases. (Disable WlAN
at your mobile device.)
3. Reduce the distance between the Soundbar and your
mobile end device.
Problem Mögliche Ursache
the device does not 1. the preset (factory setting) for the Aut
switch on automati- function is OFF (disabled).
cally from the optical
2. the device was set into standby mode using
or coaxial input.
the "Power" key.
3. the device was switched to the other digital
input which receives no signal and has swit-
ched itself off automatically.
the DM system does 1. the Sel function is deactivated (MAN).
not switch automati-
2. Bluetooth ® has been deactivated on your
cally to the Bt input.
mobile end device.
3. the DM system is connected to a different
mobile end device.
4. the mobile end device is not connected to
the DM system.
the DM system swit- this can happen when your mobile device pro-
ches to the Bt input duces system tones e.g. typing on the keyboard.
inadvertently.
the Bt input cannot the Sel function is activated (Aut).
be selected using the
"input" keys.
English
Lösung
1. Activate the Aut function (ON). (Page 45)
2. Switch the device on using the "Power" key on the re-
mote control and in future wait for it to switch itself into
standby mode.
3. Switch the device on using the "Power" key on the remo-
te control and select the digital input that is connected to
the desired source device.
1. Activate the Sel function (Aut).
2. Activate Bluetooth ® on your mobile end device.
3. Deactivate Bluetooth ® on the other mobile end device.
4. Connect your mobile end device to the DM system.
(Page 44)
1. Deactivate the Sel function (MAN).
2. Deactivate the system tones on your mobile end device.
in this case the switching process happens automatically as
soon as the DM system detects an audio signal from the
mobile end device.
53