piezosystem 12V40 Series Bedienungsanleitung Seite 29

The 12V40C/CSG voltage amplifiers do not have a casing. They should be
integrated into customer systems for OEM applications.
Pin name description
1,2,8,9 GND ground (Signal)
4 VCC +5 V output, for switching SRC
13 MON monitor signal 0...+10 V
14 MOD modulation input 0...+10 V
16 SRC source, choice of the amplifier control by HIGH or LOW TTL
level
HIGH: Pin 7 is active, OFFSET potentiometer and MOD
(modulation input) at the front panel are switched off
LOW: Pin 7 is not active, motion of the actuator will be
controlled by the OFFSET potentiometer and the MOD
(modulation input) at the front panel
24 OUT output voltage -10...+150 V (* option)
30 GND ground (operating voltage)
32 PWR + operating voltage
table 3: pin wiring of the rear panel connector (12V40C / 12V40CSG)
* option: is set at the factory, must be specified when ordering
Tel: +49(0)3641/66880 • Fax +49(0)3641/668866 • • www.piezosystem.de
info@piezojena.com
29