Orbit OCM194 Betriebsanleitung Seite 42

Orbit Controls AG
Remarks:
Overlapped command
Value is not affected by reset
Example:
TIM:SEL 0
TIM:SEL? Response: 0
:STATus:OPERation:CONDition
Syntax:
:STATus:OPERation:CONDition?
Description:
This query returns the content of Operational Condition register. It is a decimal value
which corresponds to the binary-weighted sum of all bits in the register. Register is not
cleared after this query. The response to the query therefore represents an instantaneous
'Snapshot' of the register state, at the time that the query was accepted.
Parameters:
<DNPD>
Remarks:
Overlapped command
Example:
STAT:OPER:COND? Response: 2
:STATus:OPERation:ENABle
Syntax:
:STATus:OPERation:ENABle <DNPD>
:STATus:OPERation:ENABle?
Description:
This command enables bits in the Operational Data Enable register. Selected bits are
summarized at bit 7 (OSS) of the IEEE488.2 Status Byte register.
Parameters:
<DNPD>
Remarks:
Overlapped command
Example:
STAT:OPER:ENAB 2
STAT:OPER:ENAB? Response: 2
:STATus:OPERation[:EVENt]?
Syntax:
:STATus:OPERation[:EVENt]?
Description:
This query returns the content of Operational Data Event register. It is a decimal value
which corresponds to the binary-weighted sum of all bits set in the register. Register is
cleared after this query.
Parameters:
<DNPD>
Remarks:
Overlapped command
Example:
STAT:OPER? Response: 0
:STATus:OPERation:NTRansition
Syntax:
:STATus:OPERation:NTRansition <DNPD>
:STATus:OPERation:NTRansition?
Operational Condition register
Operational Data Enable register
Operational Data Event register
42
OCM194 Hochohmige Dekade