Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Before installing and activating this controller card, please make
sure you have a complete backup of your existing data from your
hard drives. Manufacturer is not responsible for data loss due to
abuse, misuse, or neglect. Should you have any installation
problem, please contact your dealer for assistance.
HARDWARE INSTALLATION
1.
Turn off your computer and all external devices connected to it.
2.
Disconnect your computer from the power sources.
3.
Open the computer case. Refer to your computer user's manual for more details.
4.
Find an available PCI-Express 2.0 slot and remove the slot bracket. Save the bracket screw for later use.
5.
Align the controller card horizontally with respect to the slot and insert it into the slot firmly and evenly. Take
care not to force it into the slot. Once you have properly positioned the controller card into the slot, fasten it
to the computer case with the screw you have just saved.
6.
Mount the hard disk(s) on the computer case.
7.
Connect the power cable to the hard disk(s).
8.
Connect the SATA hard disk(s) to the controller card with the SATA cable(s).
9.
If you use 2.5'' SATA HDD/SSD, mount your HDD/SSD to the 7+15pin SATA port.
10. If you use NGFF B-key SSD, mount your SSD to NGFF B-key socket and secure it with screw and nuts in
the package.
11. Connect the computer case's front panel Hard Disk LED cable to pin header
12. Connect the one end of the LED cable (optional) to pin header JP10, and the other end to your
motherboard's HDD LED connector.
13. Secure the computer case and switch on your computer.
Port Configuration (Optional features)
There are some specific models in which you can change the SATA / NGFF port on the card freely by changing
the jumper header. Please refer to below table for jumper setting.
Jumpers
SATA ports
CN3
CN9
CN4
CN8
Note: All other combinations of jumper setting are invalid.
Marvell BIOS Utility (MBU) for RAID/HyperDuo Setup
Warning: All the data on the hard disks connected to the controller card will be permanently erased in
the following actions.
To create a RAID/HyperDuo virtual disk:
1.
Power up your computer. Skip this section if you are not going to create a RAID/HyperDuo virtual disk.
2.
Press the [Ctrl] + [M] key on the keyboard at the same time to enter the Marvell BIOS Utility(MBU).
3.
Once the MBU is entered, scroll to HBA0: Marvell 0 in the Topology pane by the up and arrow key on the
keyboard and press Enter.
4.
Choose Configuration Wizard and press Enter to start creating the RAID/HyperDuo virtual disk.
5.
Select the free physical disks available by using the arrow keys to scroll through the disks and press Space
Bar. After selecting all the disks needed, press Enter to continue.
6.
Choose the RAID option:
WARNING
Figure 1
JP1
JP2
JP3
1-2
1-2
1-2
2-3
2-3
2-3
2
JP9
JP9
JP4
JP5
JP6
1-2
1-2
2-3
2-3
1-2
2-3
(See Figure 1).
JP7
JP8
1-2
1-2
2-3
2-3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis