studiotechik RF 1200 P-XS PORTY Bedienungsanleitung Seite 19

HENSEL Studiotechnik User manual RF 1200 P-XS and 3000-XS
Heating
The ringflash emits heat through its flashtube. This can cause
heating up parts of the lamp head to a dangerous level.
Further do not operate ringflashes and generators in the near
of inflammable objects. Therefore make sure, that generators
and ringflashes are located far enough from inflammable
props to avoid inflaming them. Take care for sufficient air
supply and make sure that ventilation slots of the generators
are kept free.
Do not operate ringflashes and power packs unattended.
Acclimatizing
When moving the ringflash from one climatic zone to the next,
the appliance should stand in the room, in which it will be
operated, for some time before starting it up. This prevents
internal shortcuts caused by eventually condensing water.
Positioning
The ringflash can be mounted to a stand by using one of the
two threads 4 and 5, respectively (1/4" and 1/8", respectively).
The camera lens is to be led through the opening of the
ringflash and then correctly positioned and carefully fixed by
using screw 3. If a 3/8" screw is required, the screw can be
exchanged. For doing this, unscrew screw 2 on both sides,
remove the rail and insert the required screw. Then re-mount
the rail by screwing both screws 2.
The ringflash unit can be vertically and horizontally shifted
within the slots for precise positioning of the camera by using
screws 1 and 2, respectively.
The ringflash unit can also be operated without a stand by
holding the hand grip 6.
Page 17