TFA 60.2517 Bedienungsanleitung Seite 14

TFA_No. 60.2517_Anleit_D_GB_F
CUBO -
Radio-controlled alarm clock with thermometer
• Inside ferro-concrete rooms (basements, superstructures),
the received signal is naturally weakened. In extreme
cases, please place the unit close to a window and/or turn
it until the signal improves.
• The clock automatically scans the time signal at 3 a.m., 4
a.m., 5 a. m. and 6 a.m. everyday to maintain accurate
timing. During nighttime, the atmospheric interference is
usually less severe and reception is possible in most cases.
A single daily reception is adequate to keep the accuracy
deviation below 1 second.
7. Operation
• Important: Buttons will not function while scanning DCF
signal.
• The instrument will automatically quit the setting mode if
no button is pressed within 20 seconds.
• Press and hold ▲ or ▼ button in the setting mode for fast
running.
26
06.06.2011 18:02 Uhr Seite 14
CUBO -
Radio-controlled alarm clock with thermometer
7.1 Manual setting
• Press and hold MODE button in normal mode for two sec-
onds. The time zone (default: 0) is flashing. Press ▲ or ▼
button to adjust the time zone (-2, -1, 0, 1, 2). The time
zone setting is needed for countries where the DCF signal
can be received but the time zone is different from the
DCF time (e.g. +1=one hour later).
• Press MODE button again.
• 24 Hr flashes on the display. You can now choose the time
display. Press ▲ or ▼ button to choose 12 HR (PM appears
after noon on the display) or 24 HR system.
• Press MODE button to make the settings in the following
sequence: Hours, minutes, year, month, day, day-of-week
language, temperature display (°C= Celsius or °F= Fahren-
heit) and DCF reception (ON or OFF) and press ▲ or ▼ but-
ton to adjust it.
• Day-of-week language: German (D), French (F), Italian (I),
English (E), Danish (DK), Swedish (S), Finnish (FI), Norwe-
gian (N), Spanish (SP), Portuguese (P), Dutch (DU).
27