Camille Bauer KINAX N702-SSI Betriebsanleitung Seite 15

8. Electric commissioning
• Provide a separate power supply for the device in case of
consumer loads with high interference levels.
• Install the entire plant in an EMC-compatible manner.
Installation environment and wiring can affect the EMC of
the device.
9. Maintenance
The device is free of maintenance. Repairs may only be
carried out by authorized authorities.
10. Programming instruction
Control panel: The inclination transmitter is programmable
via keyboard. The keyboard is visible after
opening the blue cover.
LED
0%
Standard programming II
(Zero position programming)
Application: The measuring range (e.g. 4 - 20 mA) is ad-
justed by factory and symmetrically split (e.g.
± 45°). The range is calibrated on factory side
and should not be changed. The initial posi-
tion can be programmed via keystroke after
mounting the KINAX on the aligned object.
The instrument can be electrically connected
in any position. The adjusted measuring range
is symmetrical and starts from zero position,
e.g. the zero position corresponds always to
12 mA.
green
buttons
100%
R
red
button
+45°
1. Programming mode «on»
press quickly: 2x red (R; R; ...LED on)
2. Programming zero position
press quickly: 1x left green & right green (0% & 100%;
...LED blinks 1 s)
3. Switch sense of rotation (optional)
press quickly: 1x red (R; ...LED blinks 1 s)
4. Mode "off"
press quickly: 2x red (R; R; ...LED blinks 1 s, LED off)
To restore the factory settings (RESET):
1. Programming mode "on"
press quickly: 2x red (R; R; ...LED on)
2. Keep red key pressed (> 3 s)
(R; ...LED blinks 1 s; LED off)
11. Ordering information of variants
Description
KINAX N702-SSI
12. Accessories
Description
Connector M12x1 / 8 poles
Kit mounting clamp N7xx
Mounting plate N7xx
-45°
0°
Electrical connected
in any position
Article No.
157 562
Article no.
168 113
168 353
168 379
15