Navitel MSR700 Benutzerhandbuch Seite 20

NAVITEL MSR700 | 20
Installation
1. Stop the car engine.
2. Put the microSD card into the DVR.
Note: use a high-speed microSD card (Class 6 or above); capacity should be within 8-256 GB.
3. Secure the device on the windshield with the adhesive mount.
EN
4. Connect the car charger to the cigarette lighter socket.
5. Connect mini-USB interface to the car charger with the charger extension cord.
Note: charger extension cord can be placed along the edge of the windscreen.
6. Adjust the camera position; make sure the lens is facing parallel to the ground.
7. Start the engine; check whether the device is installed correctly.
Note: if the device is installed correctly, the indicator will glow red; the device will start up and begin recording (indicated by
flashing blue light).
Precautions
1. Use only the original charger adapter. Using another adapter may negatively affect the device's battery.
2. Do not use the device in humid or hot environment.
3. Keep the lens clean.
4. Do not disassemble the device and do not perform repairs by yourself.
5. Strictly follow the laws and regulatory acts of the region where the device is used. This device can not be used for illegal purpos-
es.
6. Permissible ambient temperature in operating mode: 0 to +35 °С. Storage temperature: +5 to +45 °С. Relative humidity: 5% to
90% without condensation (25 °С).