Technical Data; Cleaning And Maintenance; Environmental Protection - profiline YPL 1100 Originalbetriebsanleitung

Switch On/Off (B2)
Your tool starts or stops by depressing and
releasing the rocker switch. Press the bottom
of the switch to go forward(clockwise). Press
the top of the swicth to reverse(go counter-
clockwise).
Install/Remove sockets or Accessories (B3)
To install a socket on the anvil, align the hole of
the socket with the anvil and push down firmly.
To remove a socket form the anvil, pull the
socket out firmly.

Technical data

Power Supply
Power Input
No Load Speed
Square Drive
Torque
L sound pressure level:
pA
L sound power level:
WA
Vibration a :
h

Cleaning and maintenance

Always pull out the mains power plug before
starting any cleaning work.
Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow
it with compressed air at low pressure.
• We recommend that you clean the device
immediately each time you have finished using
it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water
230-240 V~/50 Hz
1010W
2200RPM
1/2"(13mm)
450 Nm
102 dB(A), K=3 dB
113 dB(A), K=3 dB
2
6,546 m/s , K=1,5 m/s
can seep into the device.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be
rep laced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
Repairs
Only use accessories and spare parts
recommended by the manufacturer.
If the equipment should fail some day in spite of
our quality controls and your maintenance, only
have it repaired by an authorized electrician.
If the supply cord of the appliance is damaged,
this has to be done by the manufacturer or his
agent or electrician in order to avoid a safety
2
hazard.

Environmental protection

End of life electrical equipment must
not be placed in household waste.
Please take it to a return point. Find
out about your nearest return point
from your council or sales outlet.
11