Troubleshooting - Schwaiger HDFS100 511 Handbuch

B. TX & RX Pairing MODE
1. First Press "MODE" key on the Receiver BOX.
2. You will see message "Connecting through Pairing ..." on screen
3. And then Press "MODE" key on the Transmitter BOX.
4. for a second, and wait for Atuo connection.
C. IR Extending function
1. Make sure the IR emitter Probe have been installed properly on the Trans-
mitter Box.
2. Make sure the IR receiver Probe have been installed properly on the
Receiver Box.
3. Use the remote controller of your source device to control the source form
the Receiver Box.
Note:
Please do not cover both HDFS100 Transmitter and Receiver with any
object. Because those object could block the air circulation.
TROUBLE SHOOTING
1. When there is no picture presented, please:
• Make sure the direct connection from source device to sink device can
work properly.
• Check if all connectors are connected well; check if all cables can support
the transmission speed. High Speed HDMI cables are recommended.
• Unplug the power cable to restart HDFS100.
2. When there is no sound:
• Please try to adjust the volume of TV.
• Check cable connection to see if it fits properly.
• Check cable to see if it supports video transmission only (DVI) or it is
damaged already.
• HDCP may not match very well at first connection; please unplug the
power cable to restart HDFS100.
HDFS100 511
13