Recording To A Minidisc From The Radio - Sharp MD-E9000H Bedienungsanleitung

Recording to a MiniDisc from the Radio

E-33
*07-E29-33-MD9000H(SEEG) 33
1
Tune in to a desired station (see page 20).
2
Load a recordable MiniDisc.
3
Select a recording mode by pressing one of the REC MODE but-
tons (SP, LP2, LP4).
At the same time, you can check the recordable time of the MD.
4
Press the REC button.
The unit will enter the recording stand-by mode.
5
Press the MD 06 06 button.
06 06 06
Notes:
Before recording an AM broadcast, enter the recording stand-by mode, and then
separate the AM loop aerial from the main unit. Adjust it so that the AM broadcast
can be tuned in most clearly.
During recording, you cannot change stations.
To interrupt recording:
Press the MD 06 button.
To resume recording, press the MD 06 button again.
To stop recording:
Press the MD button.
The recording will stop and the track number will be written on the MiniDisc.
To record the track number whilst recording:
The recording is performed as a single track.
To identify different sections of a recording, you can increase the track number at
any point during the recording process by pressing the REC button.
The track number will increase by one, and then the recording will continue.
01.4.19, 3:09 PM