Sharp MD-E9000H Bedienungsanleitung Seite 126

Using the Radio Data System (RDS) (continued)
To automatically play the traffic information
(EON-TI)
When the traffic information is broadcast, the radio switches to it automatically.
1
Tune in to an RDS station (when a station name is displayed).
2
Press the EON button when "EON" appears.
"PTY TI" will flash for about 4 seconds.
If the EON button is pressed when "EON" is not displayed, "NO EON" will
appear for 4 seconds to indicate that the unit cannot enter the EON stand-
by mode.
3
Whilst they are displayed, select the TI (Traffic Information) by
pressing the 5/3 5/3 or 2/4
5/3 5/3
5/3
4
Within 4 seconds, press the PTY. TI button.
"TI" and "WAITING" will appear for 2 seconds each.
"TI" will appear, and the unit will enter the EON-TI stand-by mode.
E-27
*07-E22-28-MD9000H(SEEG) 27
2/4 button.
2/4 2/4
2/4
5
When a TA specified starts on an ON (other network) station, the
unit will automatically switch to that station, and "TI" will flash.
6
When the traffic information is over, the unit will automatically
return to the original station.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON button. ("TI"
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON button. Within 4 seconds, press it
again. ("TI" will go out.)
01.4.19, 3:08 PM
"WAITING")