Herunterladen Diese Seite drucken

Troubleshooting - TRENDnet TEG-S081FI Schnellstartanleitung

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Troubleshooting

Q1.
How come I cannot see any light from any of my LED's?
A1.
Your TEG-S081Fi is not getting any power. Make sure that your surge protector or your
outlet is getting power and make sure that the AC Power cord is properly connected to your
TEG-S081Fi .
Q2.
I connected my fiber converter to the TEG-S081Fi using a Multimode Fiber cable with SC
connectors. However, the network activity LED does not blink. What should I do?
A2.
Go to the TEG-S081Fi and move the connector that was in the transmit side to the
receive side, and the other connector that was in the receive side to the transmit side.
Q3.
I changed my IP settings to 192.168.16.222 to access the switch, but I still cannot get
into the Web configuration page. What should I do?
A3.
Make sure there is no other network device using the same IP address. Afterwards,
consult the User's Guide to access the switch through the Console Port. Once you reach the
command line interface, perform a factory reset and try again.
Q4.
I performed a factory reset on the TEG-S081Fi, but I still cannot access the web
configuration page. What should I do?
A4.
If you are configuring more than one TEG-S081Fi, then it is possible that you are
experiencing IP conflict between these two switches. Please configure each switch one at a
time, and make sure you assign a unique IP address to each switch.
If you have any questions regarding the TEG-S081Fi, please contact TRENDnet's Technical
Support Department.
Certifications
This equipment has been tested and found to comply with FCC and CE Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received.
Including interference that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
Waste electrical and electronic products
must not be disposed of with household
waste. Please recycle where facilities
exist. Check with you Local Authority or
Retailer for recycling advice.
5

Werbung

loading