Configuration - Machery-Nagel PF-12 Bedienungsanleitung

3.2 Configuration

1. Language
Once desired language appears, hold down
back to configuration mode.
2. Date / Time
Navigate to date / time using
3. Calibration
Use
ters with the lamp. For the second calibration step the photometer PF-12 re-
quires a calibration tube (a clean NANOCOLOR
Confirm with
4. Memory
Use
5. Signal tone
Use
6. Heading
Use the arrows
with the alphanumeric keyboard.
7. Filter 8
Use
special filter via the keyboard.
8. AUTO-OFF
Using
measurement. Available times range from 5 to 20 min in 5-minute intervals
(ex factory= 5 min). Confirm your setting with
9. SYSTEM-RESET
After an additional security confirmation the photometer performs a SYSTEM-
RESET, thus restoring the state of delivery. The display then asks for a calibra-
tion. Confirm with key
10. PROG. UPDATE
In order to perform a programme update, you must first install the update soft-
ware and the new programme file (www.mn-net.com) on your computer. Before
you start the update procedure the photometer has to be connected to the com-
puter via the USB-interface. Start the update programme on the PC and set the
photometer in the update mode using the scroll
After a successful update the photometer restarts.
14
to turn on calibration. First the photometer automatically checks all fil-
.
OK
/ to turn the memory on or off and confirm by pressing
/ to turn the signal tone on or off and confirm by pressing
/ to select the desired text passage and add the heading
to select the position of filter 8 and enter the wavelength of the additional
/ you can determine the photometer's auto-off time after the last
OK
To get to the configuration mode enter
method selection mode (use
items). Press to confirm and follow the instruc-
OK
tions in the display
/ and adjust using the keyboard.
and proceed according to point 3.
)**
/ to select menu
until the instrument switches
OK
test tube filled with water).
®
.
OK
and confirmation key
in the
.
OK
.
OK
.
OK