Displaying The Date; Reset; Temperature Display In °C Or °F; Activating The Alarm - Retrotec BZ05 Bedienungsanleitung

3.2 DIsplaYIng the Date:

Press the [ADJ] button. The
date appears in the upper
third of the display in place
of the time. The month ap-
pears on the left; the day
on the right. The display
returns to the time after ap-
proximately 2 seconds. You
can also display the date for
a longer period by keeping
the [ADJ] button pressed
longer. The date display only
returns to the time after the
[ADJ] button is released.
opeRating instRuctions - Room theRmo-hygRometeR BZ 05

3.3 reset

In order to reset all set or stored data, press the RESET
button on the rear of the appliance. The appliance is then
once again in the factory preset mode.
3.4 temperature DIsplaY In °c or °f
In order to change the unit of temperature on the display
between °C and °F, press the °C/°F button on the back
of the appliance.

4.1 actIvatIng the alarm

Briefly press the [MODE] button. The alarm time appears in
the upper third of the display in place of the time; the colon
between the numbers stops flashing. Press the [MODE] button
again for approx. 1 second. The minute display of the alarm
time starts to flash. Press the [ADJ] button once to adjust the
minute display each time by one minute, or keep it pressed in
order to reach a particular number of minutes faster.
Briefly press the [MODE] button to change from minutes
to hours. The hour display starts to flash. Press the [ADJ]
B - 4