Herunterladen Inhalt Inhalt Diese Seite drucken

Operation - CombiSteel 7491.0050 Gebrauchsanweisung

Waffle maker
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ATTENTION!
The installation and maintenance of the equipment must be carried out only by qualified personal!
1. Unpack the unit and remove all packing material. Peel off the protective cover from the device.
If adhesive residue remains, remove them with a suitable solvent.
2. To handle the weight of the device place the unit on a flat and safe place which is not heat sensitive.
3. Do never place the device on a flammable surface (such as: table cloth, carpet, etc.) or in the vicinity of
combustible and flammable materials.
4. Do not place the unit near open fires, heaters or other heat sources.
5. Maintain a minimum distance of 20 cm from all sides.
6. Set the device so that the plug is accessible to disconnect the device quickly from the network if
necessary.
Technical description:
Temperature
Power
Waffle
Dim. outside
Weight

Operation

Please follow the steps below before first usage of your waffle maker:
Connect the equipment into a grounded single outlet. The unit must be grounded in a sufficient manner.
Turn on the unit by pressing the POWER-switch. The power indicator light (red) lights up.
1. Set the temperature to 300°C and run time the device with open plates ½ hour
2. Then grease the baking plates with sunflower oil and allow the unit to run for about 20min at
250°C closed.
3. Repeat the procedure as described in point 2.
4. Bake now 2-4 waffles slowly at 220-230 ° C and discard these first waffles (Without additional fat
/ oil)
5. During the process described in section 4. you will notice that the result will be better of waffle
to waffle and they get after a few back operations a clean and easily removable waffle result.
To switch off the device, bring the thermostats in position "0" and the POWER-switch to "OFF".
The support flaps of the waffle iron WE are adjustable. The back flaps are removable. By tightening
the screws attached to the arms the support flaps are raised. By loosening they are released and can
be used easily – Important HOT
WARNING! Risk of burns!
The unit will become very hot during operation! Do not touch the hot surfaces of the device. Use the handle
of the device.
Mod. KGW 2530 E
7491.0050
50 till 300°C
2,2 kW / 230V
2x Classico 8x16x2,6cm
30 x 32 x 30cm
24 kg
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis