Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Waffle maker Control
The controls are described based on the waffle maker shown below. Please note that this model is selected only
as an example to describe. For the specific model features of all waffle maker please refer to the model overview.
Installation and Connection of the waffle maker
Safety instructions
WARNING! Electric Shock Hazard!
1. The unit may be operated only from properly installed electrical outlets with a single touch!
2. Device can cause injury if not correctly installed!
3. Prior to installing the data of the local power grid must be compared with the technical specifications
of the device (the type plate)!
4. Connect the device only in accordance!
5. Do not unplug the device from the socket with the cord!
6. The power cable must not come into contact with hot parts!
7. Make sure that the cable is exposed to heat sources and not in contact with sharp edges!
Do not let the cord hang down from the table or the bar!
WARNING! Hot Surface!
During the operation, some parts of the appliance become very hot. To avoid burns, do not touch the hot parts
of the device!
1. Do not use this appliance if it is not working properly, damaged or dropped to the ground.
2. Do not use any accessories or spare parts that were not recommended by the manufacturer. This could
pose a danger to the user or cause damage to the equipment and cause personal injury. In addition the
warranty expires.
3. Do not route cables over carpeting or other heat insulation. Do not cover the cables. Keep the cables
away from work areas and do not submerge in water.
4. Do not pull the cord for moving the device. Before moving the unit always disconnect the power cord.
5. Do not wrap the cord around the device and do not bend it.
6. Protect the device from rain water, humidity and moisture.
7. During operation do not move and do not tip over the device.
6
Werbung
Inhaltsverzeichnis
