Rear Panel Layout; Specifications - Vox Ac4Tvmini Bedienungsanleitung

1. EXTERNAL SPEAKER Jack - This is used to connect the AC4TVmini to any 16ohm
cabinet.
Note ! When an external cabinet is connected, the internal speaker is disconnected.
(FYI - the AC4TVmini sounds awesome through a VOX V112TV 4 x 12" Cabinet!)
WARNING ! Always use a non-screened VOX approved speaker lead with
WARNING ! NEVER operate this amplifier without the loudspeaker load
2 . MAINS INPUT - Connect your electricity here with the supplied, detachable Mains (power)
cord.
3 . MAINS FUSE - (serious bit) The fuse provides an overall safety protection in the event
your amplifier develops and electrical fault.
The correct value of the fuse is located on the rear panel of your amplifier and should only
be replaced with one of the same value.
WARNING ! Please ensure that your amplifier is connected to the correct
WARNING ! This amplifier must always be earthed (grounded) to prevent
Power Output:
Loudspeaker:
Dimensions (W x H x D): 260 x 280 x 170 mm / 10.24 x 11.02 x 6.69 inches
Weight:
Included items:
Specifications and appearance are subject to change without notice for improvement.

REAR PANEL LAYOUT

1
the AC4TVmini Amplifier and extension cabinets.
being connected. Serious damage can occur otherwise.
mains power voltage—please check the rear panel rating plate.
If in doubt consult dealer.
the risk of electrical shock.

SPECIFICATIONS

4 Watts RMS into 16 ohm
6.5 inches 16 ohm
6.1 Kg / 13.45 lbs.
Power cable, Owner's manual
2
3
4